![]() ![]() ![]() Step 3: Preparing For Floating Shelf Mounting Hardware Also, I really need to get my stop block system reinstalled on this miter saw station, I am definitely missing having it. I decided to have the widths get smaller as the shelves got higher, both because I think it looks nice visually but also because it will help allow more light from the wall sconce I’ll be installing above these shelves to make it to the countertops below.įinally, I could cut the shelves to final length at the miter saw, setting up a stop block to make sure they were all the same length. With the faces of the shelves cleaned up, I jointed one edge again and then ripped the shelves to final width at the table saw. Once the mortises were cut, I could get the two boards that made up each shelf glued together, using plenty of glue.Īfter letting the boards sit in the clamps overnight, I ran them through the planer to clean them up, and then I could run them through my drum sander to really smooth them out. To help with alignment during the glue up, I added some Dominos, so next I laid out locations for those and cut the mortises in those locations. I also ran the opposite face of each board against the jointer fence, to cancel out any error in the squareness of my fence. I also touched up the two mating surfaces on the boards at the jointer, to make sure they were nice and smooth. I made sure to pay attention to any imperfections and try to orient those so they faced the ceiling on the topmost shelf, since that won’t be visible in the final install. With the boards flat and square on all four sides, I could lay out which boards I wanted to glue together to create my shelves. Also, if you don’t have a planer or jointer, you could just buy pre-milled lumber in the widths you need and skip the milling process all-together. When building shelving like this, the length will really be dictated by your stud locations, as you need to hit at least two studs with the mounting hardware, and my shelves ended up at 39 inches long.Īfter milling the boards flat and square at the planer and jointer, I ripped the boards to width at the table saw, cutting away as little material as I could while cleaning up the edge. I started this shelving project by breaking down some Hard Maple boards that I picked up at my local lumber dealer, Asheville Hardware. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |